MINI - 2.0d - 143-BHP - 107-KW
Geschätzte %30 mehr Leistung und %40 mehr Drehmoment
| Parameter | original | Stage 1 | Stage 2 |
|---|---|---|---|
| Leistung (Hp) | 143 | 180 | 198 |
| Drehmoment (Nm) | 305 | 400 | 440 |
Fahrzeuginformationen
| Fahrzeug: cars |
| Marke: MINI |
| Jahr: (01/2012 - Present) |
| Modell: Paceman |
| Treibstoff: Diesel |
| Motor: 2.0d - 143-BHP - 107-KW |
ECU-Informationen
| Motor Ecu: BOSCH EDC17C41DDE8 |
| : Sealed all around, remove one side |
| Lesegeräte: Above pedals |
Lesegeräte
| KESSV2: OBD - VR/ID Only |
| Kess V2 Protocollo: 692 |
| Kess V2 Aiuto: ENU_L_EDC17_BMW_MINI_DDE8 |
| Protocollo KTAG: 220 |
| KTAG Aiuto: ENU_L_EDC17_BMW_MINI_DDE8 |
| Processore KTAG: Boot(Tricore) |
| AUTOTUNER: OBD/Boot/Bench |
| X17: Boot Only |
| CMD: Boot Only |
Verfügbare Lösungen
| DPF: YES | EGR: YES |
| ADBLUE: YES | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: YES | EVAP: NO |
| HARDCUT: NO | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: YES | SPEED LIMIT: YES |
| START STOP: YES | LAMBDA: NO |
| MAF: YES | BOOST SENSOR: NO |
| SPORT DISPLAY: YES | SWIRL FLAP: YES |
| LAUNCH CONTROL: NO |
Notiz 1
To use Kess OBD it requires to be in subscription and constant internet connection
Notiz 2
When writing OBD with Kess, ensure you have good internet connection, battery charger is connected, seatbelt plugged in, keys are inside the car, and the hazard lights are on. If kess fails to write first time its fine, just repeat the process again. If push button ignition, hold button for 4 seconds until dash illuminates. Without doing this will still read but fail on write
