BMW - 2.0 - 170-BHP - 127-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 170 | 185 | 204 |
| Torque (Nm) | 200 | 222 | 244 |
Vehicle Information
| Vehicle: cars |
| Brand: BMW |
| Year: (01/2005 - 01/2008) |
| Model: 320i |
| Fuel: Petrol |
| Engine: 2.0 - 170-BHP - 127-KW |
| Chip Tuning: N46B20 |
Ecu Information
| Engine Ecu: BOSCH MEV946 |
| Reading Devices: Kick panel, driver's side |
| OBD: ENU_094300CAN1 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 216 |
| Kess V2 Aiuto: ENU_L_ME9_BMW |
| Protocollo KTAG: 103 |
| KTAG Aiuto: ENU_L_ME9_BMW |
| Processore KTAG: Bdm(MPC5xx) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: OBD Only |
| CMD: BDM |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: YES | EVAP: NO |
| HARDCUT: NO | POP & BANG: YES |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: NO |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: YES |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write
