Renault - 2.0 - 165-BHP - 123-KW
Geschätzte %30 mehr Leistung und %40 mehr Drehmoment
| Parameter | original | Stage 1 | Stage 2 |
|---|---|---|---|
| Leistung (Hp) | 165 | 200 | 220 |
| Drehmoment (Nm) | 270 | 320 | 352 |
Fahrzeuginformationen
| Fahrzeug: cars |
| Marke: Renault |
| Jahr: (01/2003 - 01/2006) |
| Modell: Megane Cabriolet |
| Treibstoff: Petrol |
| Motor: 2.0 - 165-BHP - 123-KW |
ECU-Informationen
| Motor Ecu: SAGEM S3000 |
| : Sealed all around, remove one side select |
| Lesegeräte: Below heater controls |
| OBD: ENU_MO_0090 |
Lesegeräte
| KESSV2: OBD |
| Kess V2 Protocollo: 90 |
| Kess V2 Aiuto: ENU_L_0250 |
| Protocollo KTAG: 250 |
| KTAG Aiuto: ENU_L_0250 |
| Processore KTAG: Jtag(Renesas) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: OBD Only |
| CMD: OBD Only |
Verfügbare Lösungen
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: NO | EVAP: NO |
| HARDCUT: NO | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: YES |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Notiz 1
Clean surface of probe points well, if not reading/writing clean again
Notiz 2
On keyless, put card in slot, into first gear and push button for 10 seconds until 'Remove card' comes up on dash
